MODERN DRILL GRINDER MODEL DG-675

SPECIFICATIONS:

• CAPACITY 1/4 TO 3 • ELECTRICS 115V/1/60

INSTRUCTIONSL FOR OPERATION OF MODERN DRILL BIT SHARPENER:

A. PLACE DRILL INTO TROUGH SO THAT IT OVER HANGS THE TROUGH BY ABOUT ONE HALF OF ITS DIAMETER. (IE. 3/4″ DRILL WOULD OVERHANG 3/8) AND WITH THE CUTTING EDGE TO BE SHARPENED SET AT APPROX. 5 DEGREES CLOCKWISE. (FEED BLOCK HOLDS DRILL IN PLACE) B. NOW SET THE LIP STOP NEEDLE AT ANY CONVIENT POSITION ON THE DRILL FLUTE AND LOCK IT HERE. C. WHILE HOLDING THE DRILL FIRMLY IN PLACE BY HAND, START THE MOTOR AND FEED THE DRILL INTO THE STONE BY SMALL INCREMENTS USING THE MAIN ADJUSTMENT BELOW THE TROUGH. TURN DRILL TO GRIND EACH SIDE ONE PASS AT A TIME UNTIL SHARPNESS IS ACCOMPLISHED. D. AND A FOOT NOTE: TO OBTAIN MORE DRILL CLEARANCE, INCREASE THE DEGREE CLOCKWISE. TOO OBTAIN LESS CLEARANCE DECREASE THE DEGREE CLOCKWISE. THIS MAY BE ACCOMPLISHED BY SMALL INCREEMENTS USING THE FEED BLOCK ADJUSTER.